Views: 10 Author: Site Editor Publish Time: 2023-11-20 Origin: Site
1.Clean the magnetic grid ruler mounting surface with alcohol;
2.Install the reading head support and magnetic grid ruler installation tool
Precautions:①Ensure that the clearance between the magnetic grid ruler installation tool and the magnetic grid ruler installation surface is large enough to facilitate the penetration of the grating ruler;②Ensure that the magnetic grid ruler back adhesive can be fully fitted to the grid scale mounting surface(height direction);③Ensure that the forward direction of the magnetic grid ruler installation tool is parallel with the slide table.
3.Pull the slide table to about 20cm away from one end of the profile,Insert the magnetic grid ruler without tearing the back adhesive first,pull out a section,tear the back adhesive fold and reverse through the grid ruler installation tool,and push the slide table to the end of the profile.
Precautions:①Ensure that the magnetic grid ruler is at least 10mm longer than the limit position.
4.Push the slide table to the other end of the profile while tearing the back glue,and the magnetic grid ruler is at least 10mm longer than the limit position.You can finish the last piece of magnetic grid ruler by hand.
Precautions:①Do not remove the grating ruler installation tool at this time.
5.Clean the surface of the magnetic grating ruler with alcohol
6.Do not remove the installation tool.Repeat steps 3 ~ 4 to Install grid ruler protective steel tape.
7.After all is completed,power on,and the blue light is on throughout the reading head,indicating that the installation is correct.
Magnetic Encoders from China, Magnetic Encoders Manufacturer & Supplier - ALM (autolinearmotion.com)